The output of the m0n0wall.libs file is
There are no exit codes and nothing in the logs. This is all I have. Trust
me if I had more info I could track down the issue and wouldn't have come to
the mailing lists.
I have tried to parse through the perl code as best as I can. Its not a
language I am use to. I am unable to figure out what files its checking or
where its stepping through. The best I can tell is it scans the /usr/bin and
Again Alexander I did not write the perl script. It is one that they
recommend using in the documentation. If there were more error codes I would
From: Alexander Bluem [mailto:mailinglists1 at gmx dot de]
Sent: Monday, April 24, 2006 2:58 PM
To: m0n0wall dash dev at lists dot m0n0 dot ch
Subject: Re: [m0n0wall-dev] Setup mono image problems with step 1.10
On Thu, 20 Apr 2006 12:18:03 -0600
"Brent Wilkinson" <brent at air2data dot com> wrote:
> I am trying to create a custom image of the monowall system. I get to the
> 1.10 step and when I run:
> perl mklibs.pl $MWROOT > m0n0wall.libs
> I get a line in there that gives me the error not found. Any
> on what I can look at to fix this?
in order for ANYBODY to help you, you really should specify your problem
a little more precisely. I haven't built any images myself yet, but I
assure you that if you give a little context of the error, then most
likely someone will respond.
Usually perl bitches about missing libraries which you'll have to
install. Perl mentiones WHICH ONES. Include that in your "error report".