[ previous ] [ next ] [ threads ]
 
 From:  "Junior Gillespie" <junior dot gillespie at gmail dot com>
 To:  "William Lloyd" <wlloyd at slap dot net>, m0n0wall dash dev at lists dot m0n0 dot ch, m0n0wall at lists dot m0n0 dot ch
 Subject:  Re: [m0n0wall] T1/PRI ISDN simulation
 Date:  Wed, 16 Aug 2006 16:30:02 -0500
That information is good, however I don't have implementation of that
quite yet. I would like to though.

I am located in Dallas, Tx.

Thanks,
Junior

On 8/16/06, William Lloyd <wlloyd at slap dot net> wrote:
> The easiest thing if you have the hardware would be to use a sangoma
> or digium card running asterisk.
>
> I do back to back T1/PRI stuff with it all the time.  Anything T1/PRI
> can be plugged into another.  It;'s only a question of whether the
> port is wired CPE or CO.  the are only 2 possible cables.  regular
> RJ45 ethenet straight through or a T1 crossover.  Keep in mind a T1
> crossover IS NOT WIRED THE SAME as a ethernet crossover.
>
> You can simulate loads for dialers, pbx etc.
>
> Where are you located?
>
> -bill
>
> On 16-Aug-06, at 3:33 PM, Junior Gillespie wrote:
>
> > Anyone know if its possible to simulate a T1/PRI ISDN with basic
> > software and hardware? I'm needing to test some equipment, and have
> > looked at my test equipment options, but can't justify purchasing the
> > equipment for testing a few items.
> >
> > --
> > Thanks,
> >
> > Junior
> >
> > ---------------------------------------------------------------------
> > To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
> > For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch
> >
>
>


-- 
Thanks,

Junior