[ previous ] [ next ] [ threads ]
 
 From:  Lee Sharp <leesharp at hal dash pc dot org>
 To:  'Mono Dev List' <m0n0wall dash dev at lists dot m0n0 dot ch>
 Subject:  1.8.1b540 - Hard-setting Full-Duplex fails...
 Date:  Fri, 03 May 2013 12:59:30 -0500
I am running 1.8.1b540 in semi-production.  (Production, but not user 
facing)  And it is suffering the usual "Cisco can't do autonegiotiation" 
issue...  So I hard set it in the config file.

	<interfaces>
		<lan>
			<if>em0</if>
			<ipaddr>192.168.50.1</ipaddr>
			<subnet>24</subnet>
			<media/>
			<mediaopt/>
		</lan>
		<wan>
			<if>em1</if>
			<media/>
			<mediaopt>full-duplex</mediaopt>
			<spoofmac/>
			<ipaddr>206.xxx.xxx.18</ipaddr>
			<subnet>28</subnet>
			<gateway>206.xxx.xxx.17</gateway>
		</wan>
	</interfaces>


But in the GUI and in the CLI it is back to half-duplex...

em1: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500
	options=4219b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,VLAN_HWCSUM,TSO4,WOL_MAGIC,VLAN_HWTSO>
	ether 00:25:90:67:79:f9
	inet 206.xxx.xxx.18 netmask 0xfffffff0 broadcast 206.xxx.xxx.31
	inet6 xxxx::xxx:xxxx:xxxx:xxxx%em1 prefixlen 64 scopeid 0x2
	nd6 options=41<PERFORMNUD,NO_RADR>
	media: Ethernet autoselect (100baseTX <half-duplex>)
	status: active

Is this a known bug, user error, or new surprise?

			Lee Sharp