[ previous ] [ next ] [ threads ]
 
 From:  Andrew White <andywhite at gmail dot com>
 To:  Lee Sharp <leesharp at hal dash pc dot org>
 Cc:  Mono Dev List <m0n0wall dash dev at lists dot m0n0 dot ch>
 Subject:  Re: [m0n0wall-dev] 1.8.1b540 - Hard-setting Full-Duplex fails...
 Date:  Fri, 3 May 2013 19:06:23 +0100
New surprise :) I'll take a look over the weekend unless Someone beats me to it !

Sent from my iPhone

On 3 May 2013, at 18:59, Lee Sharp <leesharp at hal dash pc dot org> wrote:

> I am running 1.8.1b540 in semi-production.  (Production, but not user facing)  And it is suffering
the usual "Cisco can't do autonegiotiation" issue...  So I hard set it in the config file.
> 
>    <interfaces>
>        <lan>
>            <if>em0</if>
>            <ipaddr>192.168.50.1</ipaddr>
>            <subnet>24</subnet>
>            <media/>
>            <mediaopt/>
>        </lan>
>        <wan>
>            <if>em1</if>
>            <media/>
>            <mediaopt>full-duplex</mediaopt>
>            <spoofmac/>
>            <ipaddr>206.xxx.xxx.18</ipaddr>
>            <subnet>28</subnet>
>            <gateway>206.xxx.xxx.17</gateway>
>        </wan>
>    </interfaces>
> 
> 
> But in the GUI and in the CLI it is back to half-duplex...
> 
> em1: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500
>    options=4219b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,VLAN_HWCSUM,TSO4,WOL_MAGIC,VLAN_HWTSO>
>    ether 00:25:90:67:79:f9
>    inet 206.xxx.xxx.18 netmask 0xfffffff0 broadcast 206.xxx.xxx.31
>    inet6 xxxx::xxx:xxxx:xxxx:xxxx%em1 prefixlen 64 scopeid 0x2
>    nd6 options=41<PERFORMNUD,NO_RADR>
>    media: Ethernet autoselect (100baseTX <half-duplex>)
>    status: active
> 
> Is this a known bug, user error, or new surprise?
> 
>            Lee Sharp
> 
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: m0n0wall dash dev dash unsubscribe at lists dot m0n0 dot ch
> For additional commands, e-mail: m0n0wall dash dev dash help at lists dot m0n0 dot ch
>