Am 21.09.2004 um 13:57 schrieb Jean Everson Martina:

> HI,
>
> 	I had the same problem two days ago witha generic pc using CF. I sent 
> the new image using the webgui and waited someting like 5 minutes, the 
> console was with the message "upgrading firmware". How log does it 
> take? So I was bored and turned off.
>
>
>
> Jean
>
> Peer Dicken wrote:
>> Hi all,
>> yesterday I disconnected my wrap from power supply, while upgrading 
>> the firmware. This turned my wrap into an unusable state. I needed to 
>> open the case, get the CF card and "repair" it with my CF-writer.
>> Well, is there any mechanism to prevent this? I think of a rescue 
>> sytem that is started, if the reset button is pushed longer during 
>> boot. the machine could then start the rescue system and write a 
>> default system to the CF card....
>> Any ideas?
>> MfG
>> Peer Dicken
>> ---------------------------------------------------------------------
>> To unsubscribe, e-mail: m0n0wall dash dev dash unsubscribe at lists dot m0n0 dot ch
>> For additional commands, e-mail: m0n0wall dash dev dash help at lists dot m0n0 dot ch
> <everson.vcf>