Hi guys

I need to make a kernel for a new embedded system board that I am trying out.

I have the patches from the m0n0 site, but there are two lots there.  Is it 
safe to assume that the ones marked as *410.tgz are the ones used in the 1.1 
kernels?

I assume the later is for the 1.2beta builds?

Also, which version of ipf should I be using?

This may seem a daft question from me, but in fact I have never had to change 
the kernels in the past with the Soekris kit I normally use.  The new boards 
are VIA C3 based using Realtek NIC's - the kernel from the generic-pc build 
works OK (after some fun with the console) but  it is a bit fat and I am 
using 35% of my 64Mb memory just loading the system so I need to do some 
trimming.

Cheers

Peter
-- 
----------------------------------------------------------------------------
Peter Curran				  Leveraging Internet Technology
Close Consultants			       for Businesses
p: +44-1225-463700			 
f: +44-1225-463705			  
e: peter at closeconsultants dot com		  
sip: peter at closeconsultants dot com 


-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.