I really needed to specify the protocol type ICMP in that rule to get the
ping to work...
----- Original Message -----
From: "Joe Doran" <joe at jbdww dot com>
To: "'V. de Bel'" <vincent dot debel at wanadoo dot nl>
Sent: Thursday, June 19, 2003 10:50 PM
Subject: RE: [m0n0wall] PC1<>LAN1<>MONO<>LAN2<>PC2
> I do have Block private networks turned off, and I had the Optional
> network set to Proto: * Source: * Port: * Destination: *
> Port: *
> And I tried what you just sent and it did not work.
> -----Original Message-----
> From: V. de Bel [mailto:vincent dot debel at wanadoo dot nl]
> Sent: Thursday, June 19, 2003 3:46 PM
> To: Joe Doran
> Subject: Re: [m0n0wall] PC1<>LAN1<>MONO<>LAN2<>PC2
> I hope you unticked "Block private networks" in your WAN
> To ping the m0n0wall make new Firewall rule:
> Proto: ICMP Source: * Port: * Destination: * Port: *
> ----- Original Message -----
> From: "Joe Doran" <joe at jbdww dot com>
> To: <m0n0wall at lists dot m0n0 dot ch>
> Sent: Thursday, June 19, 2003 10:29 PM
> Subject: [m0n0wall] PC1<>LAN1<>MONO<>LAN2<>PC2
> > Here is my situation.
> > 1)
> > PC1<>LAN1<>MONO<>LAN2<>PC2
> > PC1 = 192.168.6.60.
> > LAN1 = 192.168.6.254 / 24 Configure as LAN on M0N0Wall.
> > LAN2 = 192.168.4.65 /24 Configure as WAN on M0N0Wall. The gateway is
> > 192.168.4.254.
> > PC2 = 192.168.4.55
> > Lan 2 has a Linksys setup as the gateway to the internet.
> > I setup a NAT on the M0N0wall to forward port 80 to 192.168.6.60 on
> > When I site on PC2 and point my web browser to 192.168.4.65, it never
> > connects.
> > I have put the M0N0wall on to the internet, and I do know that NATing
> > does work, but why does this not work on the local lan.
> > 2)
> > I take it you can not ping M0N0wall on its WAN connection.
> > 3)
> > I put a pc on the DMZ side with and address of 192.168.9.50 with
> > M0N0wall DMZ set to 192.168.9.250 and I try to use the ping function
> > M0N0wall to ping 192.168.9.50 and I get time outs.
> > Thanks
> > Joe Doran