[ previous ] [ next ] [ threads ]
 
 From:  "Tracy Phillips" <tracy dot phillips at weberize dot com>
 To:  "'Chad R. Larson'" <clarson at eldocomp dot com>, "'Christiaens Joachim'" <jchristi at oce dot be>, "'Christiaens Joachim'" <jchristi at oce dot be>, <m0n0wall at lists dot m0n0 dot ch>
 Cc:  "'William Bloom'" <wbloom at eldocomp dot com>
 Subject:  RE: [m0n0wall] PorSentry Feedback
 Date:  Thu, 23 Oct 2003 12:25:47 -0500
That is where I am headed as well :-)

I want to take a look at prelude sensors and then I will start with
configuring for redundancy.

I am looking at the 4801's as well... right now I am just testing on a 1U
1GHz with cdrom/floppy.

Tracy

-----Original Message-----
From: Chad R. Larson [mailto:clarson at eldocomp dot com] 
Sent: Thursday, October 23, 2003 12:20 PM
To: Christiaens Joachim; Tracy Phillips; Christiaens Joachim;
m0n0wall at lists dot m0n0 dot ch
Cc: William Bloom

At 06:16 AM 10/23/2003, Christiaens Joachim wrote:
>Super! It's getting time for me to set up a dev system!

I'm setting up mine.  I've got a =very= old notebook (Toshiba T3400CT) that 
wasn't doing anything else.  I installed FreeBSD 4.8-p13 on it last 
night.  I'll use com1 for the console and a PCMCIA ethernet for a LAN.  The 
hacker's guide (http://m0n0.ch/wall/hack/) shows how to set up a PXE boot 
and an NFS mounted root, so you only have to burn a CF when you're sure 
you've got it right.

Along that line, is anyone working on integrating VRRP (Virtual Router 
Redundancy Protocol) RFC-2338 into m0n0wall?  If not, I think I'll give it 
a go.  We'd like to use a pair of net4801s with automated failover for our 
exterior firewalling.

I'll grant that with no moving parts, and a hardware watchdog to catch 
runaway software, a single net4801 will probably be more than sufficient, 
but we have to survive single-point-of-failure (SPOF) by our customers 
sometimes.


-- CONFIDENTIALITY NOTICE --

This message is intended for the sole use of the individual and entity to
whom it is addressed, and may contain information that is privileged,
confidential and exempt from disclosure under applicable law. If you are not
the intended addressee, nor authorized to receive for the intended
addressee, you are hereby notified that you may not use, copy, disclose or
distribute to anyone the message or any information contained in the
message. If you have received this message in error, please immediately
advise the sender by reply email, and delete the message. Thank you.