On Tue, 19 Oct 2004 22:47:01 -0500, Tom Alvarez <tom dot alvarez at gmail dot com> wrote:
> Hey,
> I'm a noob and am having some problems getting things setup.   I want
> to get in and change the baud rate to 9600 on my PCEngines WRAP .1C.
> I have the null modem cable required as well.  The problem I am having
> is that I cannot stop the boot process to change the rate.  I hit S
> and nothing happens.  I have created the m0n0wall image and it is on
> my CF card.
> 
> Are there some terminal settings that need to be changed in order to
> send commands?  I have booted the WRAP without the CF card, and it
> says to hit enter to continue, and nothing happens when I hit enter.
> So far, I'm just a little frustrated.
> 


You following the instructions on this page? 
http://m0n0.ch/wall/quickstart/initial-serialconsole.html

Do you see anything on your terminal software at all?

-Chris