Did you ever have any luck getting a m0n0wall image onto your net4526?
I have a net 4526 like yours, and am having the same difficulty. Did
you ever have any success? I set pxeboot and tftp according to the
"m0n0Wall hacker's guide" and the device successfully dhcp's an address
and seems to try to boot off the image I put in /tftpboot on my BSD
(4.10) box, but it always fails at this point with the following message:
comBIOS ver. 1.24 20040312 Copyright (C) 2000-2004 Soekris
Engineering.
net45xx
0064 Mbyte Memory CPU 80486 133 Mhz
Pri Mas 064MB ATA Flash Disk LBA 977-4-32 62 Mbyte
PXE-M00: BootManage UNDI, PXE-2.0 (build 082)
Slot Vend Dev ClassRev Cmd Stat CL LT HT Base1 Base2 Int
-------------------------------------------------------------------
0:00:0 1022 3000 06000000 0006 2280 00 00 00 00000000 00000000 00
0:16:0 1260 3873 02800001 0117 0290 10 3C 00 A0000008 00000000 10
0:17:0 13A3 0020 0B400000 0116 0280 10 3C 00 A0001000 A0002000 11
0:18:0 100B 0020 02000000 0107 0290 00 3F 00 0000E001 A0010000 05
1 Seconds to automatic boot. Press Ctrl-P for entering Monitor.
BootManage UNDI, PXE-2.0 (build 082)
BootManage PXE-2.0 PROM 1.0, NATSEC 1.0, SDK 3.0/082 (OEM52)
Copyright (C) 1989,2000 bootix Technology GmbH, D-41466 Neuss.
PXE Software Copyright (C) 1997, 1998, 1999, 2000 Intel Corporation.
Licensed to National Semiconductor
CLIENT MAC ADDR: 00 00 24 C2 B6 C0
CLIENT IP: 192.168.1.166 MASK: 255.255.255.0 DHCP IP: 192.168.1.63
GATEWAY IP: 192.168.1.254
PXE-E79: NBP is too big to fit in free base memory
PXE-M0F: Exiting BootManage PXE ROM.
No Boot device available, enter monitor.
comBIOS Monitor. Press ? for help.
>
At this point life stops, as the board does not respond to any attempt
to interact with the monitor via the terminal.
Any info would be appreciated.
-- Dave
You wrote:
>Hi,
>
>I have a Soekris net4526 with 64MB of soldered on flash memory. Are
>there instructions on how to install m0n0 wall onto it? Do I use
>PXEBoot or tftp? A tutorial would be great!
>
>Thanks,
| 