Hi Andi

How does it work when you use the live-boot-cd and a floppy, can you configure the system with that
configuration?

How much RAM do you have? A single block?

Did you load the "default" settings in your latest bios, and nothing else?

/FAF


----- Original Message ----- 
From: "a.knoth" <a dot knoth at arcor dot de>
To: <m0n0wall at lists dot m0n0 dot ch>
Sent: Thursday, November 04, 2004 10:06 AM
Subject: [m0n0wall] No keyboard input possible


Hi *

Before I`m going nuts - is there anybody out there who could help me?

I´m trying to configure m0n0wall (I tried 1.1 and 1.2b2, installed with the
m0n0wall Live installer CD as mentioned) on a FSC D-1107 PC with latest
BIOS.
Attached is a monitor, a HD (MPG3102AH, 10 GB) as primary master, a floppy
with a blank formatted disk inside, 3 x 3COM 3C905C-TX-M, a Matrox AGP
Graphic Card and a PS/2-Keyboard.
When I boot the installed m0n0wall, the menu where I can configure with
numbers 1-5 comes up and then - dead!!!
No keyboard input possible, no CTRL-ALT-DEL, nothing . - only the reset
button works.

I can see a message when m0n0wall boot that it recognized the keyboard, but
.

Any suggestions?

Or can I configure it without using the keyboard?


Thanks in advance

Andi


---------------------------------------------------------------------
To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch