> On 27.10.2003, at 00:26, Christopher M. Iarocci wrote:
 >
 > > Not a lame question, but yes, I am sure.  I enabled the OPT1 interface
 > > on
 > > the console, then in the web interface, it is configurable.  However,
 > > like I
 > > said, when I go to Status>>Wireless, it says no supported cards.
 >
 > That's OK - status display is only possible for cards that use the wi
 > driver, not an. Also, an doesn't support HostAP mode. Everything else
 > (BSS, IBSS) should work, though. The message is supposed to say that
 > there were no cards found that are supported for displaying the status,
 > not that no cards were found at all. ;)

 Thanks for confirming those things Manuel.  However, it still doesn't work.
 :-(  I get an error in the logs from the an driver that says:

 kernel: an0: record length mismatch -- expected 430, got 440 for Rid ff68

 where the expected number, the got number and the Rid number changes from
 error to error.  Upon looking up that error, I find that it shouldn't
affect
 the functionality of the card in FreeBSD 4.8, and it is caused by the
latest
 firmware revision for the card.  Even though  m0n0wall is based on FreeBSD,
 could this error be causing the card not to work?

 Chris



---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.532 / Virus Database: 326 - Release Date: 10/27/2003