Hi Bill,

I did it activating Advanced outbound NAT and not putting anything in
mapping.

Regards,

------------------------------------
Jorge Ramírez Herrera

------------------------------------
Administración de Sistemas
Área General
tecsidel
Avda. República Argentina 6, 5a planta
08023 Barcelona
Tel:          (+34) 93 292 21 10
Fax:         (+34) 93 292 28 28
mailto:<mailto:jorge dot ramirez at tecsidel dot es>
http://www.tecsidel.es/

-----Mensaje original-----
De: Bill Hamel [mailto:billh at bugs dot hamel dot net]
Enviado el: viernes, 19 de noviembre de 2004 15:22
Para: m0n0wall at lists dot m0n0 dot ch
Asunto: [m0n0wall] Can NAT be turned off in M0n0 ?

Hi all,

Other than setting up a bridge between two interfaces, can NAT (IN and OUT)
be
turned off in the M0n0wall ?

Thanks
-bh


----------------------------------------------------------------
This message was sent using IMP, the Internet Messaging Program.

--
This message has been scanned for viruses and
dangerous content by the Bugs.Hamel.Net MailScanner,
and appears to be clean.


---------------------------------------------------------------------
To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch