Well, I figured it out by playing!  I stuck another card in, setup my
OPT1 interface, and allowed traffic through the interface in the
firewall, and WHAMY!  It just plain worked!!

Scott

-----Original Message-----
From: Scott Damron [mailto:sdamron at globalmtn dot com] 
Sent: Friday, November 07, 2003 2:54 PM
To: m0n0wall at lists dot m0n0 dot ch
Subject: [m0n0wall] Interfaces and IP addresses


Hello,

Is there a way to put, say 3 nics on the m0n0wall and have two as
internal (LAN) cards?  Ie, put a single WAN IP address on the WAN side,
and have two nics internal with something like LAN1 Ip address=
10.0.0.1/8 and LAN2 ip address= 192.168.X.X/X and have both LAN nics
pass traffic to the WAN Interface?

TIA,

Scott



---------------------------------------------------------------------
To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch