Thanks.
Had to give the network card a slap and reconfigure it into plug an pray
mode.
rod

----- Original Message -----
From: "Instigater" <bloo at sveiks dot lv>
To: "M0n0wall" <m0n0wall at lists dot m0n0 dot ch>
Sent: Thursday, November 13, 2003 2:52 PM
Subject: Re: [m0n0wall] ne2k ethernet support


> No problems at all. I've tested it with two ISA ne2000s in p'n'p mode.
>
> Instigater
>
> ----- Original Message -----
> From: "Sage Telecommunications Pty Ltd" <rod at sages dot com dot au>
> To: <m0n0wall at lists dot m0n0 dot ch>
> Sent: Thursday, November 13, 2003 1:46 AM
> Subject: [m0n0wall] ne2k ethernet support
>
>
> > I am trying to use an older 'brick' unisys box as a wireless gateway.
> > Problem is that the ethernet port is a ne2k ISA clone. I have loaded the
> > monowall image onto a hard drive ok ( after RTFM and discovering that
the
> > phpdiskwrite utility will run under win98 but won't detect the hard
drive
> > <sigh> ). Is there anyway to boot into a command prompt to allow for
mods
> > for n/w drivers etc? Or has anyone else managed to get a ne2k card
running
> > under monowall?
> > thanks
> > Rod
> >
> >
> >
> > ---------------------------------------------------------------------
> > To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
> > For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch
> >
> >
> >
>
>
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
> For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch
>
>
>