When I try to set the network ports it says no linkup detected.  I am using
a cable that I know is good connected directly to my laptop.

Bryan

-----Original Message-----
From: Chris Buechler [mailto:cbuechler at gmail dot com]
Sent: Monday, December 20, 2004 11:09 PM
To: m0n0wall at lists dot m0n0 dot ch
Subject: Re: [m0n0wall] Wrap testing


On Mon, 20 Dec 2004 22:33:56 -0500, Bryan Catlin
<bryancatlin at connectgroup dot net> wrote:
> I just got a Wrap 1d-1, 2 lan and 2 pci board and used my XP laptop with a
> Lexar media adapter to write the wrap 1b3 image to a Lexar 128Mb cf card
and
> all went well it boots and still all good, but the lan ports do not seem
to
> be working.  The boot process seems to say they are all ok but with a cat
5
> plugged in nothing.
>
> Can any one give me some where to start looking?
>

Did you go through the initial setup process?  (i.e. define
interfaces, set LAN IP if you want to change it, then try to get to
the webgui)

-Chris

---------------------------------------------------------------------
To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch