I also used Soekris net4521 with 200mW
eletronics/Senao NL2511-CD pcmcia radio.
Is your problem solved?
If yes, please post your solution.
Thanks.

-------- Message original --------
> To:   	m0n0wall at lists dot m0n0 dot ch
>  From:  	Daniel Loomis <dloomis at cox dash internet
dot com>
>  Subject:  	Wireless Woes
>  Date:  	Fri, 18 Jun 2004 16:16:33 -0500
> 
> My Soekris net4521 with 200mW Teletronics/Senao
NL2511-CD pcmcia radio
> works quite well with both Pebble and Wisp-Dist. 
However, I cannot get
> the radio to link under m0n0wall 1.1b12.  
> 
> OPT1 interface has been renamed: Wireless
> 
> Information:
> 1. Wireless interface is setup in 'hostap' for use
as an AP
> 2. Bridged Wireless with LAN0 (with DHCP enabled on
LAN0) 
> 3. Also tried Wireless with it's own address/subnet
with DHCP
>    enabled on that interface
> 4. Setup firewall rule to pass any to any on LAN0
and Wireless
> 5. Tried Wireless interface with WEP disabled
> 6. Tried Wireless interface with WEP enabled using
form 0xFFFFFFFFFF
>    as encryption key 1
> 
> Wireless interface status in M0n0wall does not show
any connection.
> 
> Using Netstumbler on my laptop I get the correct
ESSID and a S/N >71,
> but no link.  I have tried linking from WinXP and
Fedora on my dual-boot
> Toshiba laptop.  I am also using an NL2511-CD in my
laptop pcmcia slot.
> Running WinXP I turn off my zonealarm firewall when
testing.
> 
> My hardware works just fine because I can replace
the CF card with one
> on which Pebble Linux is installed and everything
works.
> 
> I would like to use M0n0wall if possible, but need
wireless to work on
> this firewall/router.
> 
> Suggestions 
> 
> Dan Loomis

______________________________________________________________________ 
Post your free ad now! http://personals.yahoo.ca