I can confirm your assumption.  In testing today I found some CF or CF 
adaptors (SD-->CF) show up as secondary and some as primary with the 
BIOS set to flash=primary.  Sansdisk CF cards seem to take the setting 
from the BIOS without a problem, but others are interpreted as Secondary 
(ad1) for some reason or another.  Juts good info to have I guess.

Manuel Kasper wrote:

> On 24.11.2003, at 10:07, Bart Smit wrote:
>
>> It is a BIOS setting. You would normally make your boot device (in this
>> case the CF)  the primary. For some reason your net4801 must have had 
>> the
>> "flash" variable set to "secondary".
>
>
> I know. I just checked again, it's set to Primary, and still the CF 
> shows up as ad1. Must be related to the manufacturer of the CF card, 
> then (mine is a Lexar 64 MB).
>
> - Manuel
>
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
> For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch
>