Must be the new bsd kernel, My system refused to boot and hung on the USB
driver. After I assigned an IRQ to the USB controller everything was fine
again. So you might have more suc6 when you mess with the IRQ settings in
the bios a little.

-----Oorspronkelijk bericht-----
Van: Frans King [mailto:frans dot king at f333 dot net] 
Verzonden: woensdag 2 maart 2005 19:30
Aan: 'taharka'; m0n0wall at lists dot m0n0 dot ch
Onderwerp: RE: [m0n0wall] Sloooow bootup on Via Epia board?

Sorry I meant 1.2b3 and 1.2b5

> -----Original Message-----
> From: taharka [mailto:res00vl8 at alltel dot net]
> Sent: 02 March 2005 18:16
> To: m0n0wall at lists dot m0n0 dot ch
> Subject: Re: [m0n0wall] Sloooow bootup on Via Epia board?
> 
> Frans King wrote:
> 
> ><snip>
> >
> >I found 1.2b6 was significantly slower (30 seconds) than 1.2b5 but then
> >1.2b6 is FreeBSD 5 based and I'm using a different CF card so it could be
> >nothing to do with m0n0wall.
> >
> >
> Don't know if it makes any difference or not, but, it's my understanding
> both 1.2b5 & 1.2b6 are FreeBSD 5.3 based.
> 
> taharka
> 
> Lexington, Kentucky U.S.A.
> 
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
> For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch




---------------------------------------------------------------------
To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch