[ previous ] [ next ] [ threads ]
 
 From:  taharka <res00vl8 at alltel dot net>
 To:  m0n0wall at lists dot m0n0 dot ch
 Subject:  Re: [m0n0wall] m0n0wall hangs at boot after upgrading from 1.2b3 -> 1.2b6
 Date:  Sat, 12 Mar 2005 21:14:24 -0500
blackmesa wrote:

>The used hardware is a P133 with 64 MB.
>
>1.11 and 1.2b3 ran fine, but now I get this error at boot:
>
>md0: preloaded image (mfsroot) ...
>fatal trap 12: page fault while in kernel mode fault virtual address =
>0x0 fault code = supervisor read, page not present instruction pointer =
>0x8:0x0
>stack pointer	= 0x10:0xc1c21d50
>frame pointer	= 0x10:0xc1c21d60
>code segment	= base 0x0, limit 0xfffff, type 0x1b
>		= DPL 0, pres 1, def32 1, gran 1
>processor eflags = interrupt enabled, resume, IOPL = 0 current process =
>0 (swapper) trap number = 12
>panic: page fault
>uptime: 1s
>cannot dump. no dump device defined.
>
>Is this a known problem? Any suggestions?
>
>
>  
>
If the P133 processor is a Cyrix it may be a known problem. The Cyrix 
problem started with 1.2b5 for me. 1.2b3 & lower ran just fine. Switched 
out the Cyrix for an Intel & 1.2b5/1.2b6 boot/run OK.

taharka

Lexington, Kentucky U.S.A.