Hello to all.

I recently added a third nic to my m0n0wall, to isolate wlan traffic
from the rest of my lan. The wlan is an access point attached to a nic
and not a wireless card in m0n0wall. I was able to get it up and
running, but no matter how I configure the rules, I have unrestricted
access to the lan from opt1. I can remove all rules, add a block rule,
it doesn't seem to matter.

I am trying to allow the wlan segment full access to the wan and only
pptp access to the lan. I have included my config.xml.

[lan 10.3.0.0/24] - - [m0n0 10.3.0.4] - - [wan dhcp]
                             [opt1 10.3.1.1]
                                       |
                           [wlan 10.3.1.0/24]

Any feedback would be much appreciated.

Thanks,
Jim