|
||||||||
Hello list, I recently installed an isa->pcmcia adaptor into my m0n0wall machine. It's running pb21r560 generic-pc. I recompiled that for SMP as my board has two friendly procs on it. oh, btw new smp build is up if anyone uses it: http://students.dsu.edu/iedemam/m0n0wall/ FYI, the problems outlined below also occurred with pb20... Anyway, I cannot seem to get my wireless to function properly. I've added the interface, and setup the wireless in the same fashion as other boxes I've setup. The card beacons, but does not seem to transmit traffic at all. I've included my dmesg, and config.xml below. My roomate was able to pull an address from dhcp, and ping another host in our network (once). Any ideas? My only theory is that the 16-bit ISA controller is not going to allow my card to play nicely. ?? Maybe? --Michael I. -----DMESG------------------------ Copyright (c) 1992-2003 The FreeBSD Project. Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 The Regents of the University of California. All rights reserved. FreeBSD 4.9-RELEASE #1: Sun Nov 2 15:28:26 CST 2003 mrkasai at bastion dot undergroup dot com:/usr/src/sys/compile/M0N0WALL_GENERIC_SMP Timecounter "i8254" frequency 1193182 Hz CPU: Pentium Pro (198.67-MHz 686-class CPU) Origin = "GenuineIntel" Id = 0x619 Stepping = 9 Features=0xfbff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA ,CMOV> real memory = 536870912 (524288K bytes) avail memory = 508182528 (496272K bytes) Programming 24 pins in IOAPIC #0 FreeBSD/SMP: Multiprocessor motherboard: 2 CPUs cpu0 (BSP): apic id: 0, version: 0x00040011, at 0xfec08000 cpu1 (AP): apic id: 12, version: 0x00040011, at 0xfec08000 io0 (APIC): apic id: 13, version: 0x00170011, at 0xfec00000 Preloaded elf kernel "kernel" at 0xc0da8000. Preloaded mfs_root "/mfsroot" at 0xc0da8084. Pentium Pro MTRR support enabled md0: Preloaded image </mfsroot> 10485760 bytes at 0xc03a6ed0 md1: Malloc disk npx0: <math processor> on motherboard npx0: INT 16 interface pcib0: <Host to PCI bridge> on motherboard IOAPIC #0 intpin 18 -> irq 2 IOAPIC #0 intpin 17 -> irq 9 IOAPIC #0 intpin 16 -> irq 11 pci0: <PCI bus> on pcib0 fxp0: <Intel 82557 Pro/100 Ethernet> port 0xff80-0xff9f mem 0xff800000-0xff8fffff,0xffbe5000-0xffbe5fff irq 2 at device 6.0 on pci0 fxp0: Ethernet address 00:a0:c9:06:c3:b8 nsphy0: <DP83840 10/100 media interface> on miibus0 nsphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto isab0: <Intel 82371SB PCI to ISA bridge> at device 7.0 on pci0 isa0: <ISA bus> on isab0 atapci0: <Intel PIIX3 ATA controller> port 0xffa0-0xffaf at device 7.1 on pci0 ata0: at 0x1f0 irq 14 on atapci0 ata1: at 0x170 irq 15 on atapci0 pci0: <unknown card> (vendor=0x9004, dev=0x8078) at 9.0 irq 9 xl0: <3Com 3c905-TX Fast Etherlink XL> port 0xfe80-0xfebf irq 11 at device 11.0 on pci0 xl0: Ethernet address: 00:60:97:31:a8:67 miibus1: <MII bus> on xl0 nsphy1: <DP83840 10/100 media interface> on miibus1 nsphy1: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto xl1: <3Com 3c905-TX Fast Etherlink XL> port 0xff00-0xff3f irq 9 at device 15.0 on pci0 xl1: Ethernet address: 00:60:08:52:c9:51 miibus2: <MII bus> on xl1 nsphy2: <DP83840 10/100 media interface> on miibus2 nsphy2: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto pci0: <S3 ViRGE DX/GX graphics accelerator> at 17.0 irq 2 orm0: <Option ROMs> at iomem 0xc0000-0xc7fff,0xc8000-0xc87ff,0xe9000-0xe9fff,0xea000-0xebfff on isa0 pmtimer0 on isa0 fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0 atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0 atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0 kbd0 at atkbd0 vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0 sc0: <System console> at flags 0x100 on isa0 sc0: VGA <16 virtual consoles, flags=0x300> sio0: configured irq 4 not in bitmap of probed irqs 0 sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0 sio0: type 8250 sio1: configured irq 3 not in bitmap of probed irqs 0 pcic2: <Cirrus logic 6722> at port 0x3e0-0x3e1 on isa0 pcic2: Polling mode pccard0: <PC Card 16-bit bus (classic)> on pcic2 pccard1: <PC Card 16-bit bus (classic)> on pcic2 APIC_IO: routing 8254 via 8259 and IOAPIC #0 intpin 0 BRIDGE 020214 loaded IPsec: Initialized Security Association Processing. IP Filter: v3.4.31 initialized. Default = block all, Logging = enabled SMP: AP CPU #1 Launched! ad0: 776MB <TOSHIBA MK1926FCV> [1578/16/63] at ata0-master WDMA2 Mounting root from ufs:/dev/md0c pccard: card inserted, slot 1 ad0: raw partition size != slice size ad0: start 0, end 1590623, size 1590624 ad0c: start 0, end 10239, size 10240 ad0: raw partition size != slice size ad0: start 0, end 1590623, size 1590624 ad0c: start 0, end 10239, size 10240 wi0 at port 0x240-0x27f irq 3 slot 1 on pccard1 wi0: 802.11 address: 00:02:6f:03:ad:e3 wi0: using RF:PRISM2.5 MAC:ISL3873 wi0: Intersil Firmware: Primary 1.00.05, Station 1.02.00 xl0: transmission error: 90 xl0: tx underrun, increasing tx start threshold to 120 bytes ----CONFIG.XML------------------------------------------------ <?xml version="1.0"?> <m0n0wall> <version>1.3</version> <system> <hostname>m0n0wall</hostname> <domain>undergroup.com</domain> <password>xxxxx</password> <timezone>CST6CDT</timezone> <time-update-interval>300</time-update-interval> <timeservers>pool.ntp.org</timeservers> <webgui> <protocol>https</protocol> <certificate/> <private-key/> </webgui> <dnsserver>24.220.0.10</dnsserver> <dnsserver>138.247.32.12</dnsserver> </system> <interfaces> <lan> <if>xl0</if> <ipaddr>192.168.0.1</ipaddr> <subnet>24</subnet> </lan> <wan> <if>fxp0</if> <ipaddr>dhcp</ipaddr> <subnet/> <gateway/> <blockpriv/> </wan> <opt1> <if>xl1</if> <descr>snort</descr> <ipaddr/> <subnet>31</subnet> <bridge>wan</bridge> <enable/> </opt1> <opt2> <if>wi0</if> <descr>wireless</descr> <ipaddr>192.168.1.0</ipaddr> <subnet>24</subnet> <bridge>lan</bridge> <wireless> <mode>hostap</mode> <ssid>braincancer</ssid> <stationname>braincancer</stationname> <channel>1</channel> <wep> <enable/> <key> <value>0x1234123412</value> <txkey/> </key> </wep> </wireless> <enable/> </opt2> </interfaces> <staticroutes> <route> <interface>lan</interface> <network>192.168.50.0/24</network> <gateway>192.168.0.200</gateway> <descr>Rooftop Equipment</descr> </route> <route> <interface>lan</interface> <network>192.168.2.0/24</network> <gateway>192.168.0.200</gateway> <descr>Bobby's House</descr> </route> </staticroutes> <pppoe> <username/> <password/> <provider/> </pppoe> <pptp> <username/> <password/> <local/> <subnet/> <remote/> </pptp> <dyndns> <type>dyndns</type> <username/> <password/> <host/> <mx/> </dyndns> <dhcpd> <lan> <enable/> <range> <from>192.168.0.200</from> <to>192.168.0.225</to> </range> <staticmap> <mac>00:02:E3:XX:XX:XX</mac> <ipaddr>192.168.0.X</ipaddr> <descr>bastion (mike)</descr> </staticmap> <staticmap> <mac>00:40:F4:XX:XX:XX</mac> <ipaddr>192.168.0.X</ipaddr> <descr>spamtop (berger)</descr> </staticmap> <staticmap> <mac>08:00:46:XX:XX:XX</mac> <ipaddr>192.168.0.X</ipaddr> <descr>darkside (mike)</descr> </staticmap> </lan> </dhcpd> <pptpd> <mode>server</mode> <redir/> <localip>192.168.0.192</localip> <remoteip>192.168.0.32</remoteip> <radius> <server/> <secret/> </radius> <req128/> <user> <name>xxxxxx</name> <password>xxxxx</password> </user> <user> <name>xxxxxx</name> <password>xxxxx</password> </user> </pptpd> <dnsmasq> <enable/> <regdhcp/> </dnsmasq> <snmpd> <syslocation/> <syscontact/> <rocommunity>public</rocommunity> <enable/> </snmpd> <diag> <ipv6nat> <ipaddr/> </ipv6nat> </diag> <bridge/> <syslog> <reverse/> <nentries>100</nentries> <remoteserver/> </syslog> <nat> <rule> <protocol>tcp</protocol> <external-port>22</external-port> <target>192.168.0.X</target> <local-port>22</local-port> <descr>ssh -> bastion (mike)</descr> </rule> <rule> <protocol>tcp</protocol> <external-port>80</external-port> <target>192.168.0.X</target> <local-port>80</local-port> <descr>mrtg stats</descr> </rule> <rule> <protocol>tcp</protocol> <external-port>4662</external-port> <target>192.168.0.X</target> <local-port>4662</local-port> <descr>mldonkey</descr> </rule> </nat> <filter> <rule> <type>pass</type> <interface>wan</interface> <protocol>tcp</protocol> <source> <any/> </source> <destination> <address>192.168.0.X</address> <port>22</port> </destination> <descr>NAT ssh -> bastion (mike)</descr> </rule> <rule> <interface>wan</interface> <protocol>tcp</protocol> <source> <any/> </source> <destination> <address>192.168.0.X</address> <port>4662</port> </destination> <descr>NAT mldonkey</descr> </rule> <rule> <interface>wan</interface> <protocol>tcp</protocol> <source> <any/> </source> <destination> <address>192.168.0.X</address> <port>80</port> </destination> <descr>NAT mrtg stats</descr> </rule> <rule> <type>pass</type> <interface>pptp</interface> <source> <network>pptp</network> </source> <destination> <any/> </destination> <descr>pptp client passthru</descr> </rule> <rule> <type>pass</type> <descr>Default LAN -> any</descr> <interface>lan</interface> <source> <network>lan</network> </source> <destination> <any/> </destination> </rule> </filter> <shaper/> <ipsec/> </m0n0wall> |