----- Original Message ----- 
From: "Niklas Petersen" <niklas at vestermarken dot net>
To: "Zachary Miller" <znmiller at sbcglobal dot net>
Sent: Friday, June 03, 2005 5:16 AM
Subject: Re: [m0n0wall] Re: Running m0n0wall behind existing router


> Zachary Miller wrote:
> > I run it just fine here. My m0n0wall clients, running on 10.0.x.x (which
> > would be 10.0.0.0/16 or 255.255.0.0)
> > connect to m0n0wall, which then connects to my internal prive network,
> > running on 192.168.0.x (which
> > would be 192.168.0.0/24 or 255.255.255.0). I have a hardware-based
router
> > connecting me to the
> > internet. Because my m0n0wall clients are for the most part "unknown"
public
> > entities, I prefer to keep
> > the networks very separate, and i do not allow traffic to pass directly
> > between the two subnets, only
> > from 10.* directly out to the internet. I have had no problems with this
> > setup at all.
>
> Is m0n0wall doing the NAT, or is your router? What routes do you have
> added to your router and m0n0wall, if any?
>
> TIA.
>
> /niklas


Both are doing NAT. I have not added any routes manually
I simply have my default route set as 192.168.0.1 (my router),
nameserver as the same, and off it goes!