Hallo Chris,

Chris Buechler schrieb am 02. June 2005:

>><shellcmd>ifconfig sis0 link0</shellcmd>
>><shellcmd>ifconfig sis1 link0</shellcmd>
>><shellcmd>ifconfig sis2 link0</shellcmd>

>You sure sis supports link0?

No ;)

>while supported cards like fxp show something like "fxp0:
>Microcode loaded, int_delay: 1000 usec  bundle_max: 6".

You are right, it shows nothing when I enable link0. That might also
be the reason for the scary low CPU after switching that on. I will
remove it again, thank you for the hint.

Best regards  Frederick