On 6/5/05, Manuel Kasper <mk at neon1 dot net> wrote:
> On 04.06.05 23:09 +0200, Rolf Sommerhalder wrote:
> 
> > After turning on the filtering bridge option, I observe the same
> > behaviour of the traffic shping, e.g. delay on inbout pipes is
> > applied whereas on outbound pipes it is not.
> > 
> > The good news is that shaping of incoming traffic in filtered
> > bridging mode is working like un non-filtering bridged mode. The
> > bad news is that in both non-filtering and filtering mode, shaping
> > on outgoing traffic apparently does not work at all.
> 
> IIRC, bridged packets pass through ipfw only once - when they are
> first received on an interface. So you need to do all your shaping on
> bridged packets in the inbound path on the right interface. I don't
> think there's much we can do about this at the moment - except for
> documenting it.
> 
> - Manuel 

Is this for all setups or only where bridging is being done? 

sai