I think that the CF I am using is made by PNY. That is supposed to be
a good brand I thought. I thought that the device only used the CF
for Bootup and it ran from ram, am I wrong here? Anyway I can get a
new CF in there in a few days, if that could be the cause. What
brands are you talking about?
On 6/4/05, Ed Lentz <elentz at gmail dot com> wrote:
> Thanks for the replies
> Hi Stmok,
> I even restarted the fw, with no joy, this has happened before and I
> had to default the system. This is not the way I expect this to work.
> I read where guys have these setup for months with no issues.
> Hi Andre,
> It seems that maybe my config gets corrupted? Is that possible? My
> lan users aren't bright enough to accidently log into the M0n0. Even
> if they did I have a 15 digit password on it. I run a good virus
> checker on all my lan pcs. This is getting frustrating. Eventually I
> want to run VOIP thru this and it appears to not be very stable at
> all. Or at least the longevity of "set it and forget it" is short.
> On 6/4/05, pmok <pmok at optushome dot com dot au> wrote:
> > I've recently had a similar experience. Ver 1.11 suddenly locks up.
> > Unlike your case, I couldn't access anything, everything inbound or
> > outbound were blocked.
> > I reset the system and everything is fine again.
> > (The system was up for 10 days)
> > This is a regular PC using a Celeron 1.2Ghz with 512MB RAM.
> > (CD-ROM/Floppy version of m0n0Wall).
> > Regards
> > -Stmok
> > ----- Original Message -----
> > From: "Ed Lentz" <elentz at gmail dot com>
> > To: <m0n0wall at lists dot m0n0 dot ch>
> > Sent: Saturday, June 04, 2005 1:42 PM
> > Subject: [m0n0wall] M0n0wall stops passing inbound traffic
> > > I have a Net4501 running ver 1.11 at my office. I have rules to allow
> > > port 80,23,5900,3306 to a couple of PCs on the Lan side. I have had
> > > PPTP running as well with the M0n0wall as the server. For no apparent
> > > reason, all those ports are closed, nothing can get in. I can use
> > > them on the Lan side of the fw. This happened before when I wanted to
> > > run 1.2b7. All of this ran for about 30 days before it stopped.
> > > Looking at my rules they appear fine. I rebooted the fw with no
> > > relief. The modem I am using is a Cayman on a DSL line. It is set for
> > > Gateway mode. I have static IP addresses that have worked for almost
> > > a year. Does anyone have any ideas? Does this happen to everyone
> > > else?
> > > Ed
> > >
> > > ---------------------------------------------------------------------
> > > To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
> > > For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch
> > >
> > >