m0n0 to standalone is cross cable?

sai

On 6/6/05, Brad Smith <BSmith at dollarbank dot com> wrote:
> I have a CD and Floppy setup of M0n0wall on a system.
> 
> If I run setup for the ADSL line into the wall box, the ETH0 card fires up
> and sees the WAN. If I setup the D-Link router segment of my LAN, the wall
> box fires up ETH1. BUT, if I try to add a stand alone system ( I am trying
> to set this one up as a 1:1 NAT for it's own IP) the ETH2 card on the wall
> system is dark. If I plug the stand alone system into the D-LiNK router -
> No
> PROBLEM the router sees the computer and assigns and IP for is on the
> router.
> I have tried to set this up in all three ETH cards on the wall box, none of
> them light up when the stand alone box is plugged in.
> 
> WHY? is the firewall not seeing this stand alone system? did I miss a step?
> Why would this happen when the other WAN and LAN setups fine ?
> 
> 
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
> For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch
> 
>