[ previous ] [ next ] [ threads ]
 
 From:  "Holger Bauer" <Holger dot Bauer at citec dash ag dot de>
 To:  "Jared Patterson \(DSL AK\)" <JaredP at datacom dot co dot nz>, <m0n0wall at lists dot m0n0 dot ch>
 Subject:  AW: [m0n0wall] Using m0n0 with an external dsl router
 Date:  Wed, 22 Jun 2005 11:46:16 +0200
Your WAN-Range and LAN-Range has a conflict. /8 means that every IP starting with 10.X.X.X is
assumed at the interface with that subnetmask. Your WAN-Range is inside your LAN-Range this way. Try
a /16 on LAN or change that adressrange completely (for example 172.16.1.1 /16). What is the
subnetrange on your WAN?
I don't think this config has worked with smoothwall either this way.
 
Regards,
Holger Bauer
 


Von: Jared Patterson (DSL AK) [mailto:JaredP at datacom dot co dot nz]
Gesendet: Mittwoch, 22. Juni 2005 11:14
An: m0n0wall at lists dot m0n0 dot ch
Betreff: [m0n0wall] Using m0n0 with an external dsl router


Hi All,
 
I Have setup another little lan trying to get m0n0 to work in my current setup. All hardware in this
setup is relatively the same other than the dsl router is the model below, Dynalink RTA 220. Heres
the current setup;
 
Internal Lan - 10.1.1.0/8
 
M0n0 Lan - 10.1.1.201
 
M0n0 Wan - 10.1.20.1
 
DSL Router - 10.1.20.200
 
DSL Router currently running DHCP which assigned 10.1.20.1 to Wan.
 
PC in Internal Lan is currently on a static setup with 10.1.1.201 set as the gateway. Dont know what
is going wrong as just before this setup, I installed Smoothwall which was setup exactly the same,
and ran with no errors. Although smoothwall kinda sucks, would be wicked to get m0n0 running. 
 
Attached is the status.php as im out of ideas. Any help would be greatly appricated.
 
Cheers
 
Jared



____________
Virus checked by G DATA AntiVirusKit