Sorry, I made subnets for both lan and wan 255.0.0.0, I think I can see where I have gone wrong.
What should it be?
From: Holger Bauer [mailto:Holger dot Bauer at citec dash ag dot de]
Sent: Wednesday, 22 June 2005 21:46
To: Jared Patterson (DSL AK); m0n0wall at lists dot m0n0 dot ch
Subject: AW: [m0n0wall] Using m0n0 with an external dsl router
Your WAN-Range and LAN-Range has a conflict. /8 means that every IP starting with 10.X.X.X is
assumed at the interface with that subnetmask. Your WAN-Range is inside your LAN-Range this way. Try
a /16 on LAN or change that adressrange completely (for example 172.16.1.1 /16). What is the
subnetrange on your WAN?
I don't think this config has worked with smoothwall either this way.
Von: Jared Patterson (DSL AK) [mailto:JaredP at datacom dot co dot nz]
Gesendet: Mittwoch, 22. Juni 2005 11:14
An: m0n0wall at lists dot m0n0 dot ch
Betreff: [m0n0wall] Using m0n0 with an external dsl router
I Have setup another little lan trying to get m0n0 to work in my current setup. All hardware in
this setup is relatively the same other than the dsl router is the model below, Dynalink RTA 220.
Heres the current setup;
Internal Lan - 10.1.1.0/8
M0n0 Lan - 10.1.1.201
M0n0 Wan - 10.1.20.1
DSL Router - 10.1.20.200
DSL Router currently running DHCP which assigned 10.1.20.1 to Wan.
PC in Internal Lan is currently on a static setup with 10.1.1.201 set as the gateway. Dont know
what is going wrong as just before this setup, I installed Smoothwall which was setup exactly the
same, and ran with no errors. Although smoothwall kinda sucks, would be wicked to get m0n0 running.
Attached is the status.php as im out of ideas. Any help would be greatly appricated.
Virus checked by G DATA AntiVirusKit