While it's possible to keep them both starting with 10.x.x.x this really isn't making the job easy
for you. If you must do it this way, you cannot use 255.0.0.0 for your subnet mask. Instead of
correcting the mask, lets just change the LAN address. No reason to have a class A subnet on your
LAN unless you have a ton of computers.
Change your LAN IP to something like 192.168.X.1 with a subnet mask of 255.255.255.0. Make X
anything you like from 1-254, but I recommend not using 1, 2, 5, 10, 100. Make sure that if you
change your LAN IP address you change your DHCP server settings to reflect this (if you use DHCP).
Also make sure the box (on bottom of the general menu? Rules menu?) for "Block data from private
networks" is not checked.
From: Jared Patterson (DSL AK) [mailto:JaredP at datacom dot co dot nz]
Sent: Wednesday, June 22, 2005 3:11 PM
To: Holger Bauer; m0n0wall at lists dot m0n0 dot ch
Subject: RE: [m0n0wall] Using m0n0 with an external dsl router
My Wan is on 10.1.20.0/8 - Do you I change my lan or wan range, if so what do I make it?
From: Holger Bauer [mailto:Holger dot Bauer at citec dash ag dot de]
Sent: Wednesday, 22 June 2005 21:46
To: Jared Patterson (DSL AK); m0n0wall at lists dot m0n0 dot ch
Subject: AW: [m0n0wall] Using m0n0 with an external dsl router
Your WAN-Range and LAN-Range has a conflict. /8 means that every IP starting with 10.X.X.X is
assumed at the interface with that subnetmask. Your WAN-Range is inside your LAN-Range this way. Try
a /16 on LAN or change that adressrange completely (for example 172.16.1.1 /16). What is the
subnetrange on your WAN?
I don't think this config has worked with smoothwall either this way.
Von: Jared Patterson (DSL AK) [mailto:JaredP at datacom dot co dot nz]
Gesendet: Mittwoch, 22. Juni 2005 11:14
An: m0n0wall at lists dot m0n0 dot ch
Betreff: [m0n0wall] Using m0n0 with an external dsl router
I Have setup another little lan trying to get m0n0 to work in my current setup. All hardware in
this setup is relatively the same other than the dsl router is the model below, Dynalink RTA 220.
Heres the current setup;
Internal Lan - 10.1.1.0/8
M0n0 Lan - 10.1.1.201
M0n0 Wan - 10.1.20.1
DSL Router - 10.1.20.200
DSL Router currently running DHCP which assigned 10.1.20.1 to Wan.
PC in Internal Lan is currently on a static setup with 10.1.1.201 set as the gateway. Dont know
what is going wrong as just before this setup, I installed Smoothwall which was setup exactly the
same, and ran with no errors. Although smoothwall kinda sucks, would be wicked to get m0n0 running.
Attached is the status.php as im out of ideas. Any help would be greatly appricated.
Virus checked by G DATA AntiVirusKit