The system.php setup page for Time Interval says
"Minutes between network time sync.; 300 recommended, or 0 to disable"

Does this mean I either have to wait or reboot the box to get the
correct time for firewall logs?

At this point I am now back to using America/New_York as the time zone.
I did not change the server. still pointing to 198.82.1.201.

The m0n0wall firewall log time is still off by 5 hours...BUT, the data
sent to the syslog server (wallwatcher) is reporting the correct time.
Very strange. I am wondering if there is something in the firewall php
page that is not compensating for the difference in time ??

I have not rebooted the box yet since making these changes.

- Don

On 7/5/05, taharka <res00vl8 at alltel dot net> wrote:
> Don Munyak wrote:
> 
> >Thanks taharka,
> >
> >After trial-n-error, partial success.
> >
> >US VA ntp-1.vt.edu (198.82.1.201)
> >Location: Virginia Tech, Blacksburg, Virginia, USA
> >Synchronization: V3 Stratum 2 synced to local GPS primary servers
> >Service Area: US southeastern region, Abilene
> >Access Policy: open access
> >
> >Web GUI
> >Time zone: Etc/GMT -1
> >NTP server: 198.82.1.201
> >
> >status.php now shows the correct time, however...
> >the firewall logs are still out of sync.
> >
> >I'm still scratching my head :)
> >
> >- Don
> >
> >
> >
> >
> >
> OK, how about setting the time zone back to NY or
> America/Kentucky/Louisville? Not sure but, when I had this problem
> before I had to reboot m0n0wall after making those changes.
> 
> taharka
> 
> Lexington, Kentucky U.S.A.
> 
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
> For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch
> 
>