I cant get the the monowall to see the wireless configuration screen, that's the problem.
How can I connect to the monowall, can I connect from the WAN interface?
From: Holger Bauer [mailto:Holger dot Bauer at citec dash ag dot de]
Sent: 12 August 2005 09:09
To: m0n0wall at lists dot m0n0 dot ch; Matthew Norris-Jones
Subject: AW: [m0n0wall] Wireless Access point LAN interface?
You should find a menuentry "wireless configuration" looking similiar to this screenshot:
Hostap-mode means to run the card as Accesspoint.
Von: Matthew Norris-Jones [mailto:mattnj at red dash data dot co dot uk]
Gesendet: Freitag, 12. August 2005 10:00
An: m0n0wall at lists dot m0n0 dot ch
Betreff: [m0n0wall] Wireless Access point LAN interface?
The features list of m0n0wall suggest that the wireless can be used as an access point...
wireless support (access point with PRISM-II/2.5/3 cards, BSS/IBSS with other cards including Cisco)
i have a PRISM 2.5 card installed, and then assign this interface to the LAN side, i have allocated
it an IP address, but how do i connect to m0n0wall, and set this card to work as an access point,
setup wep key, ssid etc etc...i cant even connect to the monowall, as i dont know how to initiate a
wireless connection. (running a scan from my laptop does not show any wireless networks available)
The hardware is all tested as i have configured it on the WAN interface no problem.
Virus checked by G DATA AntiVirusKit