Hi
I have the following setup :

ISP ADSL2+ line
|
Linksys WAG354G modem/router (WAN:static public IP, LAN Static IP 192.168.1.1)
|
M0n0wall (WAN: static 192.168.1.2, LAN 192.168.0.1)
|        (LAN-side is DHCP server 192.168.0.2 - 192.168.0.254)
|
PC's and VOIP adaptors (192.168.0.x)

This setup uses 2xNAT routing, and this causes trouble for the VOIP-adaptors.
The M0n0wall is used for the "traffic shaping" feature for VOIP-traffic.

I want to use single NAT-routing. Could this be done with a "static route"
in the WAG354G and disable NAT in the M0n0wall ?

If yes, how do I configure this ?

Is this right?
In the WAG354G: Static route #1
Destination IP Address : 192.168.0.0/24
Subnet Mask: 255.255.255.0
Gateway: static public IP at the WAN-side of the WAG354G
Hop Count: 1

In the M0n0wall:
Enable Outbound NAT : yes
No defined rules in the Outbound NAT-section.

Hope you can help me
Regards
Steffen