Did you enable "Filtering Bridge" on the Advanced screen?

-----Original Message-----
From: PlanAlpha [mailto:plan dot alpha at gmail dot com] 
Sent: Wednesday, October 26, 2005 3:21 PM
To: Steve Yates
Cc: m0n0wall at lists dot m0n0 dot ch
Subject: Re: [m0n0wall] IPless firewall?

Steve-
Thanks! It's up and passing traffic without an ip. The only problem is
that the firewall isn't doing anything. I have traffic from wan ->opt1
and opt1 -> wan denied all and set to log matches. It is passing all
traffic and not logging anything.
Any suggestions?
Thanks again

On 10/26/05, Steve Yates <steve at teamits dot com> wrote:
> On Wed, 26 Oct 2005 08:57:58 -0700
> PlanAlpha <plan dot alpha at gmail dot com> wrote:
>
> > Since the network cannot be changed I'd like to put in a
> > filtering bridge. Can I use m0n0wall to do this?
>
>         You'll need three network cards.  Bridge OPT1 to WAN, and
> connect your network to OPT1.  Make the LAN interface some other IP
> range, and do not connect it to the same switch(es) as OPT1.  M0n0wall
> will insist you enter an IP address into the WAN IP page, but afterwards
> you can manually edit the config.xml file on your floppy and remove it
> (leaving that entry blank, i.e. "<...></...>".  YMMV but that worked for
> me when I had it set up that way.  You will not have the ability to use
> m0n0wall as a DNS server or (I think) DHCP server.
>
>  - Steve Yates
>  - ITS, Inc.
>  - MNP:  Modem Needs Pizza.
>
> ~ Taglines by Taglinator 4 - www.srtware.com ~
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
> For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch
>
>

---------------------------------------------------------------------
To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch