|
||||||||
Am Dienstag, den 01.11.2005, 16:10 -0500 schrieb Phil Christensen: > Hi Folks, > > I've started configuring a Soekris net4501 box with m0n0wall, and i'm > running into a strange issue. I've been unable to ping the WAN > interface of the device, so I followed the troubleshooting flowchart > in the docs. In the process of double-checking the WAN IP, I noticed > that it was missing from the status screen, despite being set > statically: > > WAN interface > Status up > MAC address xx:xx:24:c4:ea:ad > Gateway xx.x.170.161 > Media none are your sure that you have the correct network cable? I assume you have to use a cross-link-cable, because the WAN interface at a soekris is a network card not a switch port. > In/out packets 907/8 (68 KB/5 KB) > In/out errors 0/0 > Collisions 0 > > LAN interface > Status up > MAC address xx:xx:24:c4:ea:ac > IP address xx.x.170.189 > Subnet mask 255.255.255.224 > Media 100baseTX <full-duplex> > In/out packets 3617/3414 (370 KB/2.59 MB) > In/out errors 0/0 > Collisions 0 > > When I change the CIDR netmask from /27 (the correct value) to > anything else, the IP and netmask appear in the status screen, but > I'm still unable to ping the WAN address. > > Incidentally, I've also made sure there are no rules set in the > firewall, and that my client machine has its gateway set to the > proper IP (of the LAN port on the firewall box). This is basically a > stock install, the only modifications I've made are to turn off DNS > forwarding and DHCP services, and change the LAN (and WAN) addresses > to a static ip. > > I'd greatly appreciate any help, > > -phil > > --------------------------------------------------------------------- > To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch > For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch > > |