Dear Lee,
	Thanks so much for the information. I will see if I can mount them.
Do you know where I can find help on adding new drivers into the m0n0wall
image as it does not support all the NICs listed in the Freebsd hardware
list. Thanks.

Regards,
Daniel

-----Original Message-----
From: Lee Sharp [mailto:leesharp at hal dash pc dot org]
Sent: Wednesday, November 30, 2005 11:44 AM
To: m0n0wall at lists dot m0n0 dot ch
Subject: Re: [m0n0wall] Installing m0n0 from linux

From: "Daniel Ling" <daniel at argentra dot com>

> Can Linux mount the image after it is written?

You asked twice, so I will answer in this thread. :-) There are two easy
ways to peek inside an image.

The first is workon4.sh which Chris Buechler has at
http://chrisbuechler.com/index.php?id=20  I have not used this myself, but
have heard that it works.

The other is m0n0image from Michael Iedema, which is written in php, so you
will need cli php installed.  It can be found at
http://devtales.michael-i.com/2005/04/01/m0n0image-updated/  I have used
this in FreeBSD 4.11-p13, and it is quite nice.

Good luck,

                        Lee


---------------------------------------------------------------------
To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch