Hi Lee thanks for the reply.

So even though my entire diagram uses private addressing, I still can't 
route those addresses between the 2 m0n0walls?



Lee Sharp wrote:

> From: "Mark Wass" <mark dot wass at gmail dot com>
>
>> What I need is for Server#1 to connect to Server#2 but appear to be 
>> coming from OPT1 on monowall#2 (192.168.22.1)
>
>
> You will need some type of VPN for this.
>
>> The good news is that I have successfully made a connection from 
>> Server#1 to Server#2 and made it appear to be coming from 
>> 192.168.22.1, but only when using IPSEC tunnels between the correct 
>> subnets on monowall#1 and monowall#2. I would like to do this without 
>> the need for IPSEC tunnels.
>
>
> Then use PPtP.  That is it.  Private IP addresses are non-routable 
> addresses.  The only other way would be to get a whole bunch of real 
> IP addresses, and not use NAT.
>
>                        Lee
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
> For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch
>
>