[ previous ] [ next ] [ threads ]
 
 From:  Ervin Malicdem <schadow1 at gmail dot com>
 To:  Lee Sharp <leesharp at hal dash pc dot org>, m0n0wall at lists dot m0n0 dot ch
 Subject:  Re: [m0n0wall] monohotspot config
 Date:  Tue, 20 Dec 2005 16:54:19 +0800
..and because you are on WRT54G, stay away from SVEASOFT firmware. Use the
stock firmware from linksys or if you are goin third party, use HyperWRT of
any variant.

On 12/20/05, Lee Sharp <leesharp at hal dash pc dot org> wrote:
>
> From: "Chris Buechler" <cbuechler at gmail dot com>
> On 12/19/05, sunnyroot at gmail dot com <sunnyroot at gmail dot com> wrote:
>
> > > how should i set up opt 1 ?  bridged ?  im a little confused on what
> ip
> > > settings should be on my Ap in order to work with mono
>
> > The AP should just bridge over to m0n0wall's OPT port.  That means
> > plugging one of the LAN ports into the Linksys (if it's a router/AP,
> > like a WRT54G), and no other configuration is required (other than
> > setting the SSID, and anything else you might want to configure on the
> > wireless
>
> > Then assign an IP address to OPT1, like 192.168.2.1/24, and enable
> > DHCP within that range on the OPT1 interface (like
> > 192.168.2.10-192.168.2.199 or something).
>
> > Get all that working, then you'll probably want to enable captive
> > portal, if for nothing other than a click through splash screen that
> > can redirect them to your web site, or something like that.
>
> Also, since you said "linksys router" make sure you set a lan ip on the
> linksys in your m0n0wall opt1 subnet, and turn off DHCP on the
> linksys.  You
> do not want them to fight!  Just leave the linksys wan port empty.
>
>                         Lee
>
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
> For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch
>
>