I have tried installing m0n0wall on an IP350 with no success. Any experience here would be
appreciated.
The boot hangs after finding the USB devices as follows:
.......
pci0: <PCI bus> on pcib0
pci_cfgintr: can't route an interrupt to 0:9 INTA
pcic0: No PCI interrupt routed, trying ISA.
pcic0: Polling mode
pcic0: TI12XX PCI Config Reg: [pwr save][FUNC pci int + CSC serial isa irq]
pccard0: <PC Card 16-bit bus (classic)> on pcic0
pci_cfgintr: can't route an interrupt to 0:9 INTB
pcic1: <TI PCI-1420 PCI-CardBus Bridge> at device 9.1 on pci0
pcic1: PCI Memory allocated: 0x88001000
pci_cfgintr: can't route an interrupt to 0:9 INTB
pcic1: No PCI interrupt routed, trying ISA.
pcic1: Polling mode
pcic1: TI12XX PCI Config Reg: [pwr save][FUNC pci int + CSC serial isa irq]
pccard1: <PC Card 16-bit bus (classic)> on pcic1
pci0: <unknown card> (vendor=0x14e4, dev=0x5802) at 10.0 irq 11
isab0: <ServerWorks IB6566 PCI to ISA bridge> at device 15.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <ServerWorks ROSB4 ATA33 controller> port 0xf800-0xf80f at device 15.1
on pci0
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
ohci0: <OHCI (generic) USB controller> mem 0xc0010000-0xc0010fff irq 11 at devic
e 15.2 on pci0
usb0: OHCI version 1.0, legacy support
------------------------------------------------------------------------------------------------------------------------
General Software Pentium III Embedded BIOS (tm) Version 4.3--------------+
|
Copyright (C) 2000 General Software, Inc. |up - Ut
Nokia NIC Trooper BIOS Version 1.1
00000640K Low Memory Passed
Bus Dev Func VendID DevID Class Irq
|
00 00 00 1166 0009 Host Bridge
00 00 01 1166 0009 Host Bridge|
00 09 00 104C AC51 CardBus Bridge
00 09 01 104C AC51 CardBus Bridge-----------------------------------------
00 0A 00 14E4 5802 Co-Processor 11
00 0F 00 1166 0200 ISA Bridge <Esc> to continue (no save)
00 0F 01 1166 0211 IDE Controller
00 0F 02 1166 0220 Serial Bus 11 www.gensw.com
01 00 00 8086 B154 PCI-to-PCI Bridge
02 03 00 8086 1209 E
02 03 00 8086 1209 E | 