You need to add allows to the captive portal for your server IP address.
Watch the note at the bottom of the "Allow IP addresses" page that will
help to configure things correctly.
Randy Newby wrote:
> Is it possible to setup an Inbound NAT to a internal server (on the LAN)
> while Captive Portal is active on the LAN? I've configured the inbound
> nat rule and the WAN rule to allow the traffic through but am not able
> to get to the internal server. If I turn Captive Portal off the rules
> will allow access through so I know they are configured correctly.
> Unfortunately, I need to have the internal server on the LAN with the
> Captive Portal so a DMZ is not possible.
> Any advice or ideas would be much appreciated.
> Thank you.