sil wrote:
> Hi
> I'm running m0n0 on an old p200mmx and the motherboard support the wake
> on lan feature. I would like to use WOL on the Lan side to powerup mono
> since it is in the basement.
> The problem is that the cable supplied with the network card doesn't match
> the jumper on the motherboard.
> 
> The jumper on the motherboard is like those that now are used for the 
> cpu fan, and on the
> manual the pins are described as
> 1: 5v stand by
> 2: Ground
> 3: Active low
> 
> the nic is like this
> http://www.edimax.nl/download/photos/NIC/EN-9130TXA-L.jpg
> but there is no indication of the type of signal used by the cable.
> The cable has green,black and red wires.
> 
> How I connect it?

Easy ;)

RED   = +5v stand by
BLACK = GND
GREEN = Active low/high (wake signal)

Regards
--
Marko