You may want to change the hard drive access mode to CHS.

Mat Murdock



Alex Neuman van der Hans wrote:
> How did you write the image to the card? I seem to recall a few times 
> getting ISO files on CD, PKUNZIP.ZIP, etc. - are you sure the CF card 
> is properly formatted? Can you read it elsewhere? For example, if you 
> can read it in DOS, it means it's not written properly.
>
> Glenn E. May wrote:
>> I have an older Compaq Presario PC..  I have an IDE <> CF card 
>> reader, and a 16mb cf card in there..  I have written the img to the 
>> card.  When I have it in the system to boot, I get a message that no 
>> boot device exists.  I have tried all of the IDE ports, cable ports, 
>> and jumper settings on the card..  no go..
>>
>>
>> If anyone has any ideas, or if I am missing something, any help would 
>> be apreciated.
>>
>> Thanks
>> Glenn
>>
>> ---------------------------------------------------------------------
>> To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
>> For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch
>