I'm getting the following entries in my system log.

Feb 16 08:09:32     /kernel: fxp0: SCB timeout: 0xff 0xff 0xff 0xffff
Feb 16 08:09:32     /kernel: fxp0: DMA timeout
Feb 16 08:09:32     /kernel: fxp0: SCB timeout: 0xff 0xff 0xff 0xffff
Feb 16 08:09:32     /kernel: fxp0: DMA timeout
Feb 16 08:09:32     /kernel: fxp0: SCB timeout: 0xff 0xff 0xff 0xffff
Feb 16 08:09:32     /kernel: fxp0: DMA timeout
Feb 16 08:09:32     /kernel: fxp0: SCB timeout: 0xff 0xff 0xff 0xffff
Feb 16 08:09:32     /kernel: fxp0: Microcode loaded, int_delay: 1000 
usec bundle_max: 6
Feb 16 08:09:32     /kernel: fxp0: DMA timeout

Here is part of the interface section for status.php

em0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
	options=3<RXCSUM,TXCSUM>
	inet xxx.xxx.xxx.xxx netmask 0xfffffff0 broadcast xxx.xxx.xxx.xxx
	ether 00:40:48:b1:5d:53
	media: Ethernet autoselect (100baseTX <full-duplex>)
	status: active
em1: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
	options=3<RXCSUM,TXCSUM>
	inet 192.168.1.1 netmask 0xffffff00 broadcast 192.168.1.255
	ether 00:40:48:b1:5d:54
	media: Ethernet autoselect (1000baseTX <full-duplex>)
	status: active
em2: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
	options=3<RXCSUM,TXCSUM>
	inet 192.168.10.1 netmask 0xffffff00 broadcast 192.168.10.255
	ether 00:40:48:b1:5d:55
	media: Ethernet autoselect
	status: no carrier
fxp0: flags=9843<UP,BROADCAST,RUNNING,SIMPLEX,LINK0,MULTICAST> mtu 1500
	options=40<POLLING>
	inet 192.168.11.1 netmask 0xffffff00 broadcast 192.168.11.255
	ether ff:ff:ff:ff:ff:ff
	media: Ethernet manual
lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> mtu 16384
	inet 127.0.0.1 netmask 0xff000000

The card is a pci Intel 10/100 nic.  I am running this using the generic 
pc version of M0n0wall and I am running 1.21.

Any ideas on how to fix this or should I just replace the card with 
something else?

Mat