[ previous ] [ next ] [ threads ]
 
 From:  Paul Taylor <PaulTaylor at winn dash dixie dot com>
 To:  Ivan Blanco <ivan underscore blanco at idblanco dot com>, m0n0wall at lists dot m0n0 dot ch
 Subject:  RE: [m0n0wall] question???
 Date:  Mon, 27 Feb 2006 08:10:52 -0500
Perhaps this should be added to a FAQ somewhere, as this question comes up
from time to time...

You can determine the IP Address of the machine using the most bandwidth by
going to the Firewall States page and doing the following:

1.  On the firewall states page, hit the "Start New" link under "Snapshot
Control".  That will save the current stats for all firewall state entries.
2.  Wait a few seconds to give the traffic time to accumulate.
3.  Hit "View Delta".  Monowall will show you the delta values of the
current time vs. when you started the snapshot.  

If your sort order is by Bytes descending (the default), the top machines
listed there are your current top bandwidth users.  Refresh as much as you
like and you'll see the bandwidth usage for these top users in near
real-time.

Paul


-----Original Message-----
From: ivanwhite at gmail dot com [mailto:ivanwhite at gmail dot com] On Behalf Of Ivan
Blanco
Sent: Sunday, February 26, 2006 4:50 PM
To: m0n0wall at lists dot m0n0 dot ch
Subject: [m0n0wall] question???

hi everybody

I have a problem in a large network, this is that i don't know who is
taking all the bandwidth, and i can't  control that by ip because the
are many machines, how can i do this, what i think is that may be i
can recompile monowall with iftop in it, so i can detect bandwidth
use.

if so how can i??

any other ideas??

---------------------------------------------------------------------
To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch