I'm having difficulty with implementing dhcp relay, on Ver 1.21
In use is a Soekris unit with 2 ethernets (sis0 and sis1)  and 2 
wireless interfaces (wi0 adn wi1)in hostap mode. 
I am attempting to have both wireless interface  users connect to an AP 
interface and obtain it's IP address supplied by a DHCP server one hop 
out on the WAN interface.  wi0 is currently bridged with sis0, and 
appears to work as intended.  As we can't bridge a 3rd interface to the 
WAN, I thought of using the dhcp relay function.  I set wi1 as the LAN, 
and am attempting enabled dhcp relay on it, and set the destination 
server to the appropriate IP address (a DHCP server on another m0n0wall, 
directly connected to the WAN, where the NAT needs to take place). I 
believe I have added appropriate entries in the firewall rules to allow 
the DHCP requests and replies, but still no  IP address obtained on the 
2nd wireless interface.

The DHCP range will be the same netbock as the WAN.  If I set the 
wireless' interface to a different submet, then how will those users be 
able to get to that network?  If I set the wireless' interface to the 
same netblock as the WAN .. the box appears to 'break'..... usually 
can't connect to it and have to re-connect via the 2nd physical 
ethernet, and change the address on the 2nd wireless.

Thanks,
Dennis