Here is what I did to mount antenna's in my WRAP 1E-2
From: Mark Phillips [mailto:g7ltt at g7ltt dot com]
Sent: Wednesday, March 15, 2006 6:18 AM
To: Jim Thompson
Cc: m0n0wall at lists dot m0n0 dot ch
Subject: Re: [m0n0wall] Which WiFi cards for WRAP?
Thanks for this Jim.
I already have the pig tails and a bucket of antennas. I think my only
problem will be where to mount the connector. The 3 Ethernet variant of
the WRAP is a bit busy on the back panel.
FYI my next adventure into WRAP will be with their newest single port
board for use as an Asterisk PBX. I'm thinking that I can use them for
exhibitions etc were my staff have to demo our products but are nearly
always out of cell phone reach (you'd think the phone companies would
sort that out). I may even add a Wifi node to it for the sake of ease at
the stand. Nothing worse that trying to explain to a set builder where
you want your data cables only to discover they've install phone wires
Jim Thompson wrote:
> Mark Phillips wrote:
>>My Linksys WAP54G bit the dust tonight and so I thought I'd buy myself
>>a WiFi card to add into my WRAP 3C board. Anyone know which cards are
> non-beta m0n0wall:
> AP or STA mode
> prism2, prism2.5, prism3.0 cards
> STA mode
> Orinoco/Avaya/Lucent/Agere/Proxim (the 11b cards, not any 11a or 11g
> Most 1st, 2nd and 3rd generation Atheros cards
> Plus all the 'non-beta' cards
> pfSense (you didn't ask, but..)
> Nearly any Atheros based card you can currently purchase.
> All beta and non-beta cards (still no AP mode on
> Your WRAP 2C (AFAIK, there is no "3C" model) only supports miniPCI
> cards. Nearly every miniPCI card has MHF/u.fl RF connectors. You'll
> need at least one "pigtail" and antenna.
To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch