Aha!!

That would work. Thanks Brandon.



Mark, G7LTT/KC2ENI
Randolph, NJ
http://www.g7ltt.com


Brandon Kahler wrote:
> Here is what I did to mount antenna's in my WRAP 1E-2
> http://img.m0n0.ch/gallery/brandon_kahler/01_19_06_WRAP_Wireless_DSL_Large_T
> ext.jpg
> 
> Brandon Kahler
> 
> -----Original Message-----
> From: Mark Phillips [mailto:g7ltt at g7ltt dot com]
> Sent: Wednesday, March 15, 2006 6:18 AM
> To: Jim Thompson
> Cc: m0n0wall at lists dot m0n0 dot ch
> Subject: Re: [m0n0wall] Which WiFi cards for WRAP?
> 
> 
> Thanks for this Jim.
> 
> I already have the pig tails and a bucket of antennas. I think my only
> problem will be where to mount the connector. The 3 Ethernet variant of
> the WRAP is a bit busy on the back panel.
> 
> FYI my next adventure into WRAP will be with their newest single port
> board for use as an Asterisk PBX. I'm thinking that I can use them for
> exhibitions etc were my staff have to demo our products but are nearly
> always out of cell phone reach (you'd think the phone companies would
> sort that out). I may even add a Wifi node to it for the sake of ease at
> the stand. Nothing worse that trying to explain to a set builder where
> you want your data cables only to discover they've install phone wires
> instead.
> 
> Mark, G7LTT/KC2ENI
> Randolph, NJ
> http://www.g7ltt.com
> 
> 
> Jim Thompson wrote:
> 
>>Mark Phillips wrote:
>>
>>
>>
>>>Hi folks,
>>>
>>>My Linksys WAP54G bit the dust tonight and so I thought I'd buy myself
>>>a WiFi card to add into my WRAP 3C board. Anyone know which cards are
>>>supported?
>>
>>
>>non-beta m0n0wall:
>>AP or STA mode
>>    prism2, prism2.5, prism3.0 cards
>>
>>STA mode
>>    Orinoco/Avaya/Lucent/Agere/Proxim (the 11b cards, not any 11a or 11g
>>card)
>>
>>1.2b5-1.2b7:
>>    Most 1st, 2nd and 3rd generation Atheros cards
>>    Plus all the 'non-beta' cards
>>
>>pfSense (you didn't ask, but..)
>>    Nearly any Atheros based card you can currently purchase.
>>    All beta and non-beta cards (still no AP mode on
>>Orinoco/Avaya/Lucent/Agere/Proxim
>>
>>Your WRAP 2C (AFAIK, there is no "3C" model) only supports miniPCI
>>cards.   Nearly every miniPCI card has MHF/u.fl RF connectors.  You'll
>>need at least one "pigtail" and antenna.
>>
>>Jim
>>
> 
> 
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch
> For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch
> 
>