[ previous ] [ next ] [ threads ]
 
 From:  "Steebe" <steebe at centrum dot cz>
 To:  <m0n0wall at lists dot m0n0 dot ch>
 Subject:  StartUP and SETUP :-(
 Date:  Wed, 21 Jan 2004 19:38:28 +0100
a.. download the raw CF/IDE image (see below)  

                OK

  a.. write the image to a CF card (> 5 MB) or an IDE hard disk, either with dd under FreeBSD or
under Windows with my tool, physdiskwrite 0.4 
    a.. FreeBSD:
    gzcat generic-pc-pbxrxxx.img | dd of=/dev/rad[n] bs=16k
    where n = the ad device number of your CF card (check dmesg) 
    b.. Linux:
    gunzip -c generic-pc-pbxrxxx.img | dd of=/dev/hdX bs=16k
    where X = the IDE device name of your CF card (check with hdparm -i /dev/hdX) - some adapters,
particularly USB, may show up under SCSI emulation as /dev/sdX 
    c.. Windows:
    (use the -u flag if the target disk is > 800 MB - make very sure you've selected the right
disk!!)
    physdiskwrite [-u] generic-pc-pbxrxxx.img
    (you must use v0.3 or later!) 

    OK
    d.. 
  b.. put the CF card/HD into the target PC 

  OK

  a.. plug the PC into the network (LAN/WAN/...) 

  OK - I have cards : Wireless Zcomax XI-626 PCI and Ethernet 3Com ISA

  a.. power it up 
            OK
  a.. assign functions (LAN/WAN/OPT) to your interfaces (hint: use the MAC addresses to tell you
which card is which one)

  OK 

  a.. change the LAN IP address, or use the default (192.168.1.1; m0n0wall acts as a DHCP server by
default) 

  OK - IP target PC : 10.0.79.1  netmask 255.255.255.0 
  my IP PC : 10.0.79.2 netmask 255.255.255.0



  Pleas help me :-(