Bjoern Euler wrote:
> Ole Barnkob Kaas wrote:
>> works fine - until after a reboot. To make it work again I simply go 
>> to the Outbound NAT page and hit "Save". Any ideas why?
> 
> Hi,
> 
> when it is working, I suggest you go to 
> <your.m0n0.ip/status.php#ipnat%20-lv> and copy the list of active filters.
> 
> Then do a reboot, go to the page again _before_ you hit the "Save" 
> button and compare the filters.
> Are there differences?
> 

They are the same before and after:

List of active MAP/Redirect filters:
map fxp0 from 10.0.0.0/8 ! to 10.0.0.0/8 -> 0.0.0.0/32 proxy port ftp 
ftp/tcp
map fxp0 from 10.0.0.0/8 ! to 10.0.0.0/8 -> 0.0.0.0/32 portmap tcp/udp auto
map fxp0 from 10.0.0.0/8 ! to 10.0.0.0/8 -> 0.0.0.0/32


Some further investigation:

After a reboot I can ping a host at the far end of the tunnel from a 
host behind the m0n0wall - but not from the m0n0 it self. I get a "No 
route to host" until I hit the save button on the outbound page.

So this is not a problem for the hosts behind m0n0. It a problem because 
  I would like to manage m0n0 from the far end of the tunnel - which I 
can when I have hit the save button on the outbound page.

/Ole