|
||||||||
I just tried this again, after unpacking the .img (again, this is the plain, vanilla, downloaded image), then ONLY re-packing it again with the script (again no errors)-- I made no changes to the file system, and still no luck- I can not ping or otherwise see the FW... This of course points to something not right in the unpack / pack procedure for me, or something I'm just leaving out... Jason P Jones MCSE+I,MCT,CCNA,LCP,CCA,CNA,CIWA,INET+,Network+,A+ Integracon Technologies 865.382.7400 -----Original Message----- From: Jason P Jones [mailto:jjones at integracon dot com] Sent: Sunday, January 25, 2004 10:21 PM To: 'Michael Iedema'; m0n0wall at lists dot m0n0 dot ch Subject: RE: [m0n0wall] Editing rootfs image and Creating CF image Thank you for the assistance, Since the last email I installed FreeBSD 4.9, installed the ports I needed, unpacked the .img using your script, edited my configs as I wanted, and repack them into an image (also using your script). When I try to recreate the image with -x it runs and creates an image file, I can load this image to a CF card using the physdisk util on Windows, but I never get any response from the firewall for a ping / etc after a reboot. I did not change anything significant, as I just wanted to test. Any ideas? Jason P Jones MCSE+I,MCT,CCNA,LCP,CCA,CNA,CIWA,INET+,Network+,A+ Integracon Technologies 865.382.7400 -----Original Message----- From: Michael Iedema [mailto:iedemam at pluto dot dsu dot edu] Sent: Sunday, January 25, 2004 2:22 PM To: 'Jason P Jones'; m0n0wall at lists dot m0n0 dot ch Subject: RE: [m0n0wall] Editing rootfs image and Creating CF image > Hello, > I'm interested in editing the downloaded rootfs image and then > creating a CF .img file- just like the downloadable one, for the > soekris net45xx boxes. I > will be doing this on either Gentoo or W/XP. I do like the ease of the > physdiskwrite utility, so Windows instructions would be > handy, but I use > linux just as much so... As far as I know there is no way to unpack and edit the images in windows. My Linux stupidity is showing through here, but if there is a 'vn' device equivalent then a quick edit of my unpacker script should get you going (http://mrkasai.undergroup.com/m0n0wall). Otherwise I would find a tired old box and throw FreeBSD 4.9 on it. That's the easiest route, and the route the hackers guide (http://m0n0.ch/wall/hack/) was written for. Hope that helps, --Michael I. --------------------------------------------------------------------- To unsubscribe, e-mail: m0n0wall dash unsubscribe at lists dot m0n0 dot ch For additional commands, e-mail: m0n0wall dash help at lists dot m0n0 dot ch |